Brodit 513605 Scheda Tecnica Scaricare il pdf (Pagina 2)

1. 2.

INSTALLATION INSTRUCTIONS

4.3.

Please read all of the instructions and look at the pictures before attaching the holder. Important Note: Route the

cable from the holder into the vehicle dashboard and route the power cable from the charger unit to the power

supply source in the vehicle and connect as follows: 1. Connect the White wire to a Negative Ground connection

of the vehicle or the vehicle chassis. 2. Connect the Red wire to a 12/24 Volt power supply in the vehicle that is

controlled by the ignition switch of the vehicle.

1. If using your TC55 with the slim battery you first need to attach the distance plate. Slide the distance plate onto

the back of the holder. Lock it into position using the enclosed screw.

2. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.

3. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed

screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Tighten the screw

until the holder is firmly in place, but still can be adjusted.

4. The holder is in place.

2(2)

1 2

Nessun commento

Brodit 513605 Scheda Tecnica Pagina 2